Skip to main content

Bulk Install for Minut sensors

Install many Minut sensors quickly with a shared installer link. The installer doesn't need a Minut account or app.

Written by Emilie Pain

Bulk install means setting up many sensors in a short time. In Minut, you do this with the Installer App feature. An installer sets up each sensor by scanning it with a phone, and doesn't need a Minut account or the Minut mobile app.

Which sensors work with Bulk Install with Installer App

  • Minut E1 sets itself up automatically once it's powered on and online.

  • Minut M3 joins your organization automatically, but only if a G1 router is nearby.

  • All other cases (other models, or M3 without a G1 nearby): use the normal installation in the Minut app.

Before you start

  • Your organization needs a Minut account, and the units must already exist in it. Bulk Install with Installer App only links a sensor to an existing unit. It doesn't create units.

  • An admin must turn on Installer App. This setting is only in the web app, not the mobile apps:

    • Minut app: Settings > Features > Installer App (admins only)

    • Minut Residential app: Settings > Installer App
      When turning it on, choose how long it stays on (from 1 hour up to 2 weeks). It switches itself off after that. If you can't see the setting, contact us.

  • The sensor must be able to get online by itself. The installer page doesn't ask for Wi-Fi details, so the usual Wi-Fi setup steps don't apply. The sensor connects either:

    • through its Ethernet cable (E1 on PoE), or

    • through another Minut device nearby that's already online, for example a G1 router.
      If neither is available, install the sensor with the Minut app instead.

  • Only ordered sensors. Only sensors shipped as part of an order can be installed this way. Demo units or samples not linked to an order can't.

How it works

  1. Share the installer link
    On the Installer App settings page, the admin copies the organization's installer link (or shows it as a QR code) and shares it with the installers.

  2. Open the link
    The installer opens the link on their phone. A web page with a QR code reader opens.

  3. Scan the sensor
    Point the phone at the QR code on the back of the sensor (the one with the MAC address). If the camera can't read it, type the MAC address in instead.

  4. Pick the unit
    Choose the unit where the sensor will be installed. Only units that already exist in your organization are shown.

  5. Move on to the next sensor
    Once the sensor is powered on and online, it completes enrollment automatically.

Good to know

  • Turning Installer App off ends any installation in progress, and the installer link stops working.

  • Install sessions last one hour. When an installer opens an install page, that session is valid for one hour. This is separate from how long Installer App stays on. If a session expires, open the installer link again to start over.

  • Rate limiting. Installation is rate-limited to prevent misuse. This doesn't affect normal installs.

  • Privacy. The session doesn't expose sensitive information such as the full MAC address or your organization ID.

Troubleshooting

"Device not allocated"

The sensor isn't part of a shipped order, so it can't be installed with Bulk Install with Installer App.

The installer link doesn't work

Installer App may have switched off after the time the admin chose. Ask an admin to turn it on again.

The camera can't read the QR code

Type the MAC address printed on the back of the sensor instead.

The sensor doesn't finish setting up

Check that it's powered on and can get online through PoE or a nearby Minut device that's already online. If not, install it with the Minut app.

The session expired

Open the installer link again to start a new session.

I selected the wrong unit

Make sure the unit you select is the right one for the sensor. To change it, restart the process.

If you still need help, contact us at hello@minut.com.

Did this answer your question?